Toshiba HDD-J35, Owner'S Manual

Page: 37 / 88

37
time yet.
4.
Now that your PC has been properly configured,
you can highlight “YES” on the TV screen and
press the “ENTER” button on the remote control.
5.
After selecting “YES”, you will see the current
software version on the TV screen. Make sure this
software version is different from the version of the
new software file stored on your PC. Select “YES”
again to proceed with the download.
6.
Now click on the “Send” button on your PC
HyperTerminal to start uploading the new
software.
7.
On the TV screen, you will see the window with a
status bar indicating the download progress.
8.
When download is completed, the recorder will
reboot automatically. You can now exit
HyperTerminal.
9.
After the recorder is booted up, you will see a
message window informing you that the recorder’s
database is empty. Note that the password will
also be reset to the default “0000”. Now press the
“TOP MENU” button and select your region of
residence.
10.
On the Main Menu, select “PROFILE” and then
“INFORMATION” to confirm the current software is
indeed changed to the new one. You can then
proceed to tune your recorder by following
“INSTALLATION” instructions on page 33.
Note: It is safe to turn off the recorder only
after the
recorder has booted up automatically. Do not
disconnect the recorder from the power source
during the software update process. If there is a
power failure during this time, the recorder may
become unusable. In this case, contact your
local dealer.
Over time, Automatic Software Upgrade service will be available as broadcasters transmit new software of your
recorder. It is recommended to carry out the software upgrade so that the recorder is equipped to perform better.
1.
When a new version of software for Toshiba HDD-
J35 is found, an OSD appears prompting for a
software upgrade.
2.
Press the “ENTER” button to accept the software
upgrade or the “EXIT” button to cancel.
3.
If the software upgrade has been accepted, all
ongoing recording(s)
will be stopped and the
system will be rebooted. Upon startup,
downloading of the new software will take place.
Progress is shown on the front panel display with
an “OTA” and a running line.
4.
The downloading process usually takes a short
while and when it has completed, the system will
reboot again. Upon the second startup, the system
has completed the upgrading process and the
database will be empty as default. Then proceed
with the Installation process. (Refer to page 33)
RE
CE
IV
ING