Toshiba EN655, Instruction Manual

Page: 30 / 104

Chapter3Settings
6F8C1566
16 16
3.1 Switch Settings
The switches for the operation mode and station address are found in the front panel of the EN655
module. The switch settings will be explained in the following subsections.
◆
IMPORTANT
・Please perform switch settings of the operation mode and station address before turning the
power supply on.
3.1.1 Station address setting switch (STN-H、STN-L)
The station address setting switches are hexadecimal rotary-type switches used to set
the station address of the Ethernet network.
For details on station address settings, refer to “3.2 Network Parameter Settings.”
The station address (1 to 254) assigned during system configuration will be set using
hexadecimal code. All nodes in the system will each be assigned different addresses.
Table 3-1 shows the station address settings.
Table 3-1 Station Address setting
Name Setting
Setting Range：01～FE(h)
STN-H STN-H(high order address)：0～F(h)
STN-L
STN-L(low order address)：0～F(h)
(Note) The symbol (h) implies hexadecimal notation.
REMARK
・ For the settings, use a small flat-blade screwdriver (tip width：2.0~2.5mm thickness:
0.5~0.6mm).
Set the station address in hexadecimal notation. For instance, given the address is 28,
the equivalent in hex is ‘1C’(h), perform the settings as follows.
STN-H: ‘1’
STN-L: ‘C’
Refer to ‘Decimal-hexadecimal conversion table’ for more details.
NOTE
・ Make sure that there are no duplication of node addresses.