16
EN
Connecting to a TV
Connect the unit to a TV after considering the capabilities of
your existing equipment.
Connect the antenna or cable to the ANTENNA
IN jack of this unit.
Connect the ANTENNA OUT jack of this unit to
the Aerial jack of your TV.
Connect AV1 (TV) Scart socket of this unit to
the Scart socket of your TV.
Note
• If your TV does not have a Scart socket, use a Scart/RCA
cable to connect.
• Connect this unit directly to the TV. If the AV cables are
connected to a VCR, pictures may be distorted due to the
copy protection system.
• When changing the “Video Out” setting (“SCART (RGB)”,
“Component (Interlace)” or “Component (Progressive)”),
connect to the corresponding jack on the TV. If the setting is
changed, for example, to “Component (Interlace)” or
“Component (Progressive)” while the scart cable is
connected to the TV, a distorted video signal may be output.
If your TV has component video input jacks, use a component
video cable (to connect the COMPONENT VIDEO OUTPUT
jacks) and an audio cable (to connect the AUDIO OUT
(ANALOG L
\
R) jacks).
When using this type of connection, “Video Out” setting
should be set to “Component (Progressive)” or “Component
(Interlace)”. Refer to “Video Out” on page 66.
• Component connection provides the better quality picture.
Connect the COMPONENT VIDEO OUTPUT
jacks of this unit to the component video input
jacks of your TV.
Connect the AUDIO OUT (ANALOG L
\
R) jacks
of this unit to the analogue audio input jacks of
your TV.
• After you have made the connections, set the “Video Out”
setting. (See page 66.)
Selecting Progressive Scan (576p/480p or
Interlaced 576i/480i) Playback
• If your TV is compatible with progressive scanning (576p/
480p), connect the TV to the COMPONENT VIDEO
OUTPUT jacks of this unit and set “Video Out” setting to
“Component (Progressive)” in “Setup” menu. (See page 66.)
Next, set your TV to the progressive scan mode.
• If your TV is not compatible with progressive scan, set
“Video Out” setting to “Component (Interlace)”.
• Use a commercially available adaptor if the video input jacks
of your TVs or monitors are the BNC type.
• Only component and HDMI connections are compatible with
the Progressive Scan.
Connections
Before installation, unplug your TV and
this unit
Using the Scart socket
2
1
RF cable
(not supplied)
RF cable
(supplied)
Cable
Signal
or
To Aerial jack
Antenna
1
2
Scart cable
(not supplied)
Scart/RCA cable (not supplied)
Audio/video cable
(not supplied)
Scart adaptor
(not supplied)
Using the COMPONENT VIDEO OUTPUT
Jacks and the AUDIO OUT
(ANALOG L
\
R) Jacks
Y
PB/CB
PR/CR
1
2
Audio IN
Component
video IN
Audio cable
(not supplied)
Component
video cable
(not supplied)
1
2
E7TE0BD_EN.book Page 16 Friday, March 5, 2010 5:08 PM