Toshiba DeviceNet nv Series, Instruction Manual, Page: 116 / 159

Chapter 6 Troubleshooting
6F8C1686
100
Table 6-5 Comparison of Module Status Code O: Supported, X: Not supported
Code DN611A Event DN611B Remarks
0 Normal status O
1 Transmission not enabled O
2 No data flow in the transmission line O
3 Communication error O
4 Scan list disagrees with the actual slave
composition. O
5 Network error O
6 Network power error detected. O
9 Busoff is detected. O
10 A duplicated node address is detected. O
Table 6-6 Comparison of Node Status Detail O: Supported, X: Not supported
Code Event DN611B Remarks
70 Detects an error in duplicate node address check. O
72 Cannot communicate with slave devices. O
73 Vendor ID, product type, and product code of a
slave device differ from those on the DN611B scan
list. O
75 No slave device exists on the network. No slave
device is registered on the scan list. O
76 DN611B has detected communication timeout due
to no response from slave devices. O
77 Slave device transmission size differs from that on
the DN611B scan list. O
78 DN611B unable to start transmission to slave
devices. O
79 DN611B unable to send to slave devices. O
80 DN611B's communication port is in idle mode. O
81 DN611B's communication port is in fault mode. O
82 Send/receive data fragment error O
83 Slave device initialization refused. O
84 Slave device initialization not completed. O
85 DN611B receive buffer overflow O
91 DN611B busoff O
92 DN611B network power error O