4. SYSTEM MODE (For Service Persons and System Administrators)
EO13-33005
4.5 Printer Parameter Fine Adjustment
4- 50
4.5.8 Paper Size for ESC/POS Setting (PAPER SIZE)
This parameter is used for label size setting at the ESC/POS mode.
Notes:
1. When
the
[FEED]
key is pressed, the menu moves in the opposite direction from when the
[PAUSE]
key is pressed.
2. When
the
[PAUSE]
key is pressed while the
[FEED]
key is held down, or when the
[POWER]
key is
pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
3. When
the
[PAUSE]
key or
[FEED]
key is pressed for 0.5 seconds or more during this fine adjustment
setting, repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the fine adjustment value becomes effective when the
[POWER]
key is pressed after
setting, then stored in the backup memory.
5. The factory default value is 58mm for the B-EP2 and 114mm for the B-EP4.
6. This setting is effective only in the ESC/POS mode. There is no command to set paper width in the
ESC/POS mode. If a paper of which width is short for the print width, the print start position may be
outside of the paper. To prevent this problem, the width of paper to be loaded in the printer must be
specified.
[PAUSE]
PAPER SIZE 25mm
PAPER SIZE 26mm
PAPER SIZE 57mm
PAPER SIZE 58mm
[FEED]
B-EP2D Series
(Range: 25 ~ 58mm, Factory default:58mm)
[PAUSE]
PAPER SIZE 50mm
PAPER SIZE 51mm
PAPER SIZE 113mm
PAPER SIZE 114mm
[FEED]
B-EP4D Series
(Range: 50 ~ 114mm, Factory Default: 114mm)
