1. INTRODUCTION
EO13-33005
1.2 Operation Panel
1- 6
(8) LCD message and LED indication
LED Indication
No.
LCD Message
STATUS
Printer Status
Restoration
by PAUSE
key Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE
Online mode
-----
Yes
ON LINE
Online mode (communicating)
-----
Yes
1
ON LINE
Strip wait
-----
Yes
2 COVER OPEN
The cover was opened in online state.
----- Yes
3 PAUSE ****
Pause state
Yes
Yes
4 COMMS ERROR
∆
A parity, overrun, or framing error has
occurred during a communication by RS-
232C.
Yes Yes
5 PAPER JAM ****
∆
A paper jam has occurred during paper
feed.
Yes Yes
6 NO PAPER ****
∆
The media has run out, or the media is not
loaded properly.
Yes Yes
7 NO PAPER
∆
The label has run out after issuing the label
successfully.
Yes Yes
8 COVER OPEN ****
∆
A feed or printing was attempted with the
Front Cover opened.
(except when the [PAUSE] key is pressed)
Yes Yes
9 HEAD ERROR
∆
The print head has a problem.
Yes Yes
10 EXCESS HEAD TEMP
∆
The print head is overheated.
(71°C or more).
No Yes
11 SAVING ####&&&&
In writable character or PC command save
mode
----- Yes
12 FORMAT ERROR
∆
An error has occurred in formatting the
flash ROM.
No Yes
13 FLASH WRITE ERR.
∆
An error has occurred in writing to the
flash ROM.
No Yes
14 FLASH MEM FULL
∆
Saving failed because of an insufficient
capacity of the flash ROM.
No Yes
15 EEPROM ERROR
∆
Data cannot be read from/written to a
backup EEPROM properly.
----- -----
16 LOW BATTERY
□
The battery voltage
7.2V or less
(B-EP2D model)
14.0V or less
(B-EP4D model)
No Yes
17 AMBIENT TEMP ERR
∆
An ambient temperature is below -20°C or over
60°C.
Yes Yes
18 BATT. TEMP ERROR
∆
The battery is in a dangerous condition.
Care must be taken not to get burned.
No Yes
19 HIGH VOLT. ERROR
∆
The battery is in a dangerous condition.
No
Yes
