Start-up
6.3 Setting for optimum depth of water
The highest point of the propeller must be at least 5 cm below the surface of the wa-
ter.
1. Release the M5 screw on the clamping ring/control triangle.
2. Release the quick clamp on the clamping ring/control triangle.
3. Place the combination of control triangle, motion link, and clamping ring in the
desired position.
4. Fix the clamping ring/control triangle onto the shaft by closing the quick clamp.
5. Tighten the clamping ring/control triangle using the M5 screw to 3.5 Nm (31 lb/
in).
6.4 Attaching the steering
1
Fig. 59:
Small fixing pin
1
Small fixing pin
The small fixing pin (1) fixes the steering if the kayak/boat is to be steered via rudder
or a pre-installed steering system.
1. Fix the small fixing pin (1) to the bracket using a cord.
2. Locate the drill hole in the control triangle above the drill hole in the motion link.
3. Push the small fixing pin (1) through the drill hole up to the stop.
4. Check the fixing.
page 90 / 128
