Start-up
Adapter plate
Fig. 49:
Installation of adapter plate
1. Place the bracket with trim mechanism flush on the adapter plate.
2. Fix the bracket with trim mechanism using four M8 screws, eight washers (four
on top, four on the bottom) and four nuts onto the adapter plate, and tighten to
a torque of 16 Nm (140 lb/in).
3. Place the adapter plate in the intended location.
4. Attach the adapter plate.
5. Check that the bracket is tightly fitted.
Unthreaded drill holes on the kayak/boat (drill template)
Fig. 50:
Installation using a drill template
1. Place the drill template in a suitable location (flat, central) on the end of the
kayak/boat. The drill template is at the end of the instructions.
ADVICE
The distance between the rear two drill holes and the rear must not exceed
105 mm (4.1 in).
2. Drill four holes, diameter 8.5 mm (0.35 in).
3. Place the bracket with trim mechanism flush on the holes.
page 83 / 128
