Start-up
4. Fix the bracket with trim mechanism using four M8 screws, eight washers (four
on top, four on the bottom) and four nuts over the drill holes, and tighten to a
torque of 16 Nm (140 lb/in).
5. Check that the bracket is tightly fitted.
6.2 Installation of the drive to the kayak/boat
CAUTION!
Damage to the boat and system if the motor is removed when the boat is
in the water!
Material damage can result.
■
Install/remove the motor only on land.
ADVICE
Depending on the length of the control cords, there are two different possibili-
ties for mounting the control triangle and the clamping ring.
6.2.1 Top control cords
1
2
3
1
Control triangle
2
Top control cords
3
Motion link with quick clamp
page 84 / 128
