Torqeedo Cruise 2.0 FP, Operating Manual

Page: 82 / 96

82
Deutsch
English
Display Cause What to do
E70
Battery outside temperature
range during charging
System can be operated when battery is inside temperature
range again. Disconnect the charger for better cooling.
Switch battery OFF and ON.
E71
Battery outside temperature
range during discharging
System can be operated when battery is inside temperature
range again. Stop or reduce current drawn from battery for
better cooling. Switch battery OFF and ON.
E72
Battery FETs outside
temperature range
System can be operated when battery is inside temperature
range again. Switch battery OFF and ON.
E73 Overcurrent during discharging Remove cause for overcurrent. Switch battery OFF and ON.
E74 Overcurrent during charging
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
E75 Pyro-fuse released Contact Torqeedo service.
E76 Voltage too low Charge battery.
E77
Voltage too high during
charging
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
E78 Battery over-charged
Disconnect charger. Use only Torqeedo charger. Switch
battery OFF and ON.
E79 Electronic battery malfunction Contact Torqeedo Service.
E80 Deep discharge Contact Torqeedo Service.
E81 Water-sensor deployed
Ensure that the battery is dry/in a dry place. If needed clean
battery housing incl.its water detector. Switch battery OFF
and ON.
E82
Disbalancing among different
batteries
Charge all batteries individually to full.
E83 Software version error
Batteries with different software versions were connected.
Contact Torqeedo Service.
E84
Number of batteries does not
match enumeration process
results
Check battery connections. The expected number of
batteries is shown in the display under the error code. Check
function of individual batteries. Potentially re-establish
communication between motor and battery as described
under 5.3.1.1.
E85 Disbalancing within one battery
During the next charging process: do not disconnect charger
from the battery. Leave charger connected to the battery
after the charging process is completed for at least 24 hours.
Battery error codes (only in combination with Power 26-104)
Display Cause What to do
E30 Motor communication
error
Check the motor cable’s plug-in connection. Check the
motor cable for damage.
E32 Remote throttle Check the plug-in connections. Check the cable.
E33 General communication
error
Check the plug-in connections and cables. Switch the
motor off and on again.
E43 Battery empty Charge battery. Motor can potentially be used again slowly
from the stop position.
Other error
codes
Faulty Contact Torqeedo Service and notify them of the error
code.
No function of
display
No voltage or defective Check the voltage supply source, the main fuse, and
the main disconnect switch. In case of fault-free voltage
supply: Contact Torqeedo Service.