76
Deutsch
English
5.3 Remote throttle control with integrated display and magnetic kill switch
5.3.1 Use of battery charge display when operating with Power 26-104 battery
5.3.1.1 Establishing communication between Power 26-104 and
Cruise FP / Enumeration
To establish communication between the Cruise FP and Power 26-104, a one-time enume-
ration process is required. Before you begin, make sure all batteries are connected and all
are turned on. The enumeration process only works if the system can locate and commu-
nicate with the batteries.
Switch the main switch of your system to the ON position.
Then push the following buttons in rapid succession: first the ON-OFF button underneath
the display (in the remote throttle control), and right afterwards (briefly) the CAL button
underneath the display.
The screen will now change to ENU and display the start of the enumeration procedure.
The components establish the communication with each other automatically. The screen
will display the progress of the enumeration in percent and the number of detected bat-
teries.
After the process is completed, the progress counter shows 100% and the number of
connected batteries.
Restart the system after completion of the process by pushing the ON-OFF push-button.
Motor and battery(ies) are now communicating directly with each other. This allows you
to see the batteries‘ current state of charge at all times and ensures that your throttle
displays an accurate range.
Please note: enumeration process must be repeated when changes are made to the
battery bank, or if a different battery bank is provided. Otherwise, error E84 will be dis-
played.
Summary of Contents for Cruise 2.0 FP
