Torqeedo Cruise 2.0 FP, Operating Manual

Page: 81 / 96

81
Deutsch
English
5.3.3 Malfunctions / emergency situations
There are 3 ways to stop the motor:
1. 2. 3.
Turn remote throttle control
to stop position Remove magnetic
on/off key Switch main switch of cable set
to OFF
5.3.4 Error message / Troubleshooting
• All repair works shall be performed by authorized Torqeedo service
centres only. Any unauthorised attempts at repair or reconstruction will
result in immediate guarantee and warranty forfeiture.
• Please note that opening the pylon or the internal shaft head cover will
result in guarantee and warranty forfeiture.
• In warranty cases please observe the warranty information at the begin-
ning of these operating instructions.
Display Cause What to do
E02 Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E05 Motor/propeller blocked Switch main switch to ”OFF” position, then remove
blockage and turn propeller one revolution by hand.
Reconnect motor cable.
E06 Voltage in the motor too
low
Low battery charge status. Motor can potentially be used
again slowly from the stop position.
E07 Motor overcurrent Continue at low output.
E08 Circuit board overheating Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E21 Remote throttle control
calibration defective
• Re-calibrate: Press “cal” button for 10 seconds.
• The display shows “cal up”: Return remote throttle
control forward to full throttle then press the “cal” button.
• The display shows “cal stp”: Return remote throttle
control to central position then press the “cal” button.
• The display shows “cal dn”: Return remote throttle
control backward to full throttle then press the “cal” button.
E22 Magnetic sensor defective Re-calibrate (refer to E21)
E23 Value range false Re-calibrate (refer to E21)