Servicing the Spark Plug
Service Interval:
Every 50 hours—Check the spark plug.
Every 100 hours—Replace the spark plug.
Ensure that the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug and a
gapping tool or feeler gauge to check and adjust the air gap.
Install a new spark plug if necessary.
Type:
Champion RC12YC, Autolite 3924, NGK BCPR6ES
or equivalent
Air Gap:
0.76 mm (0.03 inch)
Removing the Spark Plug
1.
Disengage the blade-control switch (PTO).
2.
Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
3.
Disconnect the wire from the spark plug (Figure 33).
G017865
1
Figure 33
1.
Spark-plug wire
4.
Clean around the spark plug to prevent dirt from falling
into the engine and potentially causing damage.
5.
Remove the spark plug and metal washer.
Checking the Spark Plug
1.
Inspect the spark plug (Figure 34).
Note:
If you see light brown or gray on the insulator,
the engine is operating properly. A black coating on the
insulator usually means that the air cleaner is dirty.
Figure 34
1.
Center electrode insulator
3.
Air gap (not to scale)
2.
Side electrode
Important:
Do not clean the spark plug. Always
replace the spark plug when it has a black coating,
worn electrodes, an oily film, or cracks.
2.
Check the gap between the center and side electrodes
(Figure 34).
Note:
Bend the side electrode if the gap is not correct.
Installing the Spark Plug
1.
Install the spark plug and the metal washer.
Note:
Ensure that the air gap is set correctly.
2.
Tighten the spark plug to 20 N-m (15 ft-lb).
3.
Connect the wire to the spark plug.
27
Summary of Contents for TimeCutter SS 3216
Page 44: ...Schematics G014644 Electrical Diagram Rev A 44 ...
Page 45: ...Notes 45 ...
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...