Toro TimeCutter SS 3216, Operator'S Manual

Page: 18 / 48

Using the Smart Speed
™
Control
System
The Smart Speed™ Control-System lever, located below the
operating position (Figure 18), gives the operator a choice to
drive the machine at 2 ground speed ranges—high and low.
G 014475
1
Figure 18
1. Smart-speed lever
To change speeds:
1. Move the motion control levers to neutral and outward
to the park position; disengage the blade control switch.
WARNING
Removing your hands from the motion-control
levers while the machine is in motion can
result in a loss of control causing harm to you
or bystanders.
Always stop the machine and move the
motion-control levers to the park position
before adjusting the Smart Speed™ Control
System.
2. Adjust the lever to the desired position.
Driving Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion-control levers
forward (Figure 17).
G008952
Figure 19
To go straight, apply equal pressure to both
motion-control levers (Figure 17).
To turn, release pressure on the motion-control lever
toward the direction you want to turn (Figure 17).
The farther you move the motion-control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion-control levers to neutral.
18