Toro Spray Master, Operator'S Manual

Page: 66 / 88

Brake Maintenance
Adjusting the Parking
Brake
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 51) .
2. Check the air pressure in the drive tires; refer to
Checking the Tire Pressure (page 65) .
3. Disengage the parking brake.
4. Loosen the 2 jam nuts on the brake linkage
located at the left, rear side of the machine
(
Figure 89 ).
5. To increase the brake force, turn the linkage
counterclockwise 1 to 2 turns (
Figure 89 ).
6. Engage the parking brake and check if you need
to further adjust the parking brake; repeat step
5 , if needed.
7. Tighten the 2 jam nuts ( Figure 89 ).
g313365
Figure 89
1. Jam nut 2. Brake linkage
8. Check the parking brake; repeat steps 4 to 7 ,
if needed.
Belt Maintenance
Replacing the Belt
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 51) .
2. Raise the machine and support it with jack
stands.
3. While holding the eye bolt in place, loosen the
locknut on the eye bolt to remove tension from
the spring (
Figure 90 ).
g313342
Figure 90
1. Locknut 2. Eye bolt
4. Pull the tension arm away from the belt and
remove the existing belt from the pulleys (
Figure
91 ).
g313344
Figure 91
1. Tension arm
66