Toro Spray Master, Operator'S Manual

Page: 44 / 88

7. Release the trigger for the wand and return it to
the tool clip on the machine; refer to
Spraying
with the Spray Wand (page 40) .
8. Move the boom sprayer-control valves to the
O
FF
position, set the sprayer-pump switch to the
O
FF
position, and shut off the engine.
9. Clean the strainer; refer to Cleaning the Strainer
(page 44) .
10. Repeat steps 2 through 9 using cleaners and
neutralizers recommended by the chemical
manufacturers; refer to
Filling the Tank (page
39) .
11. Repeat steps 2 through 9 using clean water only.
Cleaning the External Components
1. Using a hose to wash off the outside of the
sprayer tank with clean water.
Note:
Do not use a power washer to clean
the machine. The high-pressure water
may force residual corrosive materials into
spreader-spreader components.
2. Remove and clean the sprayer nozzles; refer to
Cleaning the Sprayer System and Wand (page
43)
.
Note:
Replace damaged or worn nozzles.
3. Allow the spreader-sprayer to completely dry
before the next use.
Cleaning the Strainer
Service Interval: After each use
Important:
If you used wettable-powder
chemicals, clean the strainer after each time that
you rinse the sprayer tank.
1. Rotate the left tank and right tank return and
suction valves to the closed position (
Figure 52 ).
g311408
Figure 52
1. Left tank return valve
(open position) 3. Right tank suction valve
(open position)
2. Left tank suction valve
(open position) 4. Right tank return valve
(open position)
2. Align a drain pan under the strainer ( Figure 53 ).
g311413
Figure 53
44