Toro Pro Sweep 07068, Operator'S Manual

Page: 15 / 40

8
Connecting the Hydraulic
Hoses
No Parts Required
Procedure
Connect the hydraulic hoses from the machine to the
quick couplers on the towing vehicle (
Figure 14 ).
g030511
Figure 14
1. Hydraulic hoses 2. Harness
Important:
Make sure that the brush rotates in
the proper direction (when viewed from the motor
end, the brush should rotate clockwise). If the
brush is rotating counterclockwise, reverse the
hydraulic hose connections.
Note:
Mark the high-pressure hose with a cable tie to
identify the correct hose installation ( Figure 15 ).
g011010
Figure 15
1. High-pressure hose 2. Cable tie
9
Connecting the Harness
No Parts Required
Procedure
Connect the harness from the machine to the power
harness on the towing vehicle (
Figure 14 ).
Note:
Ensure that the harness cannot get pinched
in the hitch and that it is not on top of or around the
hitch pin.
10
Mounting the Windrow
Blades
Parts needed for this procedure:
1 Blade-mounting assembly
2 Bolt (7/16 x 3-1/4 inches)
4 Small washer (1/2 inch)
1 Large washer
1 Spacer
2 Locknut (7/16 inch)
1 Chain
1 Bolt (3/8 x 1-1/4 inches)
1 Flange nut (3/8 inch)
1 Snap link
Procedure
1. Secure the blade mounting assembly to the left
end of the machine frame with a bolt (7/16 x
3-1/4 inches), 2 small washers, a large washer,
and a locknut (7/16 inch).
Note:
Position components as shown in Figure
16 .
2. Secure the windrow blade to the mounting
assembly with a bolt (7/16 x 3-1/4 inches), 2 flat
washers, a spacer, and a locknut (7/16 inch).
Assemble the components as shown in
Figure
16 .
15