Toro Pro Sweep 07068, Operator'S Manual

Page: 33 / 40

Replacing the Remote
Batteries
The handheld remote is powered by 4 AAA batteries.
When installing batteries, observe proper polarity as
marked on the inside of the compartment to avoid
damaging the unit.
1. Remove the 6 screws from the back of the
remote and remove the cover (
Figure 40 ).
Note:
If possible, leave the rubber seal and
steel gasket in the channel when removing the
cover and batteries.
g029817
Figure 40
1. Screw 4. Steel gasket
2. Cover 5. Batteries
3. Seal
6. Handheld remote
2. Remove the discharged batteries and properly
dispose in accordance with local regulations.
3. Plug each fresh battery into a terminal cradle
observing proper polarity.
Note:
If the batteries are improperly installed,
the unit will not be damaged, but it will fail to
operate.
4. If you accidentally removed the rubber seal and
the steel gasket, replace them carefully into the
channel in the handheld remote.
5. Replace the cover and secure it with the 6
screws removed previously (
Figure 40 ) and
torque them to 1.5 to 1.7 N∙m (13 to 15 in-lb).
Note:
Do not overtighten the screws.
Storage
1. Thoroughly clean the machine so that it is free
of dirt, leaves, and debris.
2. Check the tire pressure. Refer to Checking the
Tire Pressure (page 23) .
3. Check all fasteners and tighten them as
necessary.
4. Grease all the grease fittings. Wipe off any
excess lubricant.
5. Check the condition of the brush and replace it
if necessary.
33