Toro Pro Sweep 07068, Operator'S Manual

Page: 11 / 40

5. Loosen the jam nuts securing the proximity
switch to the frame and lower the switch until
it is 2.6 to 4.0 mm (0.10 to 0.16 inch) from the
sensing plate on the hitch tongue (
Figure 4 ).
Tighten the jam nuts to secure the adjustment.
g011587
Figure 4
1. Proximity switch 4. Sensing plate
2. Jam nut 5. Hitch tongue
3. 2.6 to 4.0 mm (0.10 to 0.16
inch)
4
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1 Rear actuator tab
4
Bolt (1/2 x 2 inch)
8 Flat washer (0.531 x 0.063 inch)
4 Locknut (1/2 inch)
2 Bolt (3/8 x 1-1/4 inch)
2 Pin assembly
2 Flange nut (3/8 inch)
Procedure
1. Mount the rear actuator tab to the machine
frame with 4 bolts (1/2 x 2 inch), 8 flat washers
(0.531 x 0.063), and 4 locknuts (1/2 inch).
Position the components as shown in
Figure 5 .
g011261
Figure 5
1. Rear actuator tab 2. Machine frame
2. Secure each end of the hydraulic cylinder to an
actuator tab with a pin assembly, a bolt (3/8 x
1-1/4 inch), and a flange nut (3/8 inch)
Figure 6 ).
Note:
Make sure that the rod end (working end)
of the cylinder is attached to the front actuator
tab.
g011260
Figure 6
1. Front actuator tab 3. Hydraulic cylinder
2. Rear actuator tab 4. Pin assembly
11