Toro Pro Force 44552, Service Manual

Page: 70 / 134

Toro Wireless Module (TWM) Handheld Remote (Models 44552,
44552TE, and 44553)
g278931
Figure 21
1. Remote transmitter
4. Screws (6 each)
2. LED 5. Gasket
3. AAA (1.5V) alkaline battery (4 used) 6. Steel backer
The handheld remote is a solid state electrical device that sends and receives
radio frequency (RF) signals to and from the RF2CAN module. The handheld
remote to RF2CAN module range should be approximately 4.6 m (15 ft). The
handheld remote can only be associated to one specific RF2CAN module. Refer
to the machine
Operator’s Manual for the handheld remote to RF2CAN (base)
association procedure.
The remote transmitter activates (powers up) when you press any button. Then,
when a button on the remote transmitter is pressed, the LED on the remote
should illuminate indicating the remote is attempting to transmit a signal. To
conserve battery power, the remote transmitter times out and powers down, all
remote transmitter LED activity stops until any button on the remote is pressed.
The remote transmitter is powered by 4 AAA (1.5V) alkaline batteries. If the
range of the transmitter has diminished or the transmitter LED does not illuminate
when a button is pressed, the batteries should be replaced.
The diagnostic light should illuminate while a button on the hand held remote is
pressed. This feature can be used to:
•
confirm the association between the hand held remote and the RF2CAN
module
•
check the hand held remote operating range
•
check the hand held remote battery condition
•
check the hand held remote button operation
Electrical System: Testing the Electrical Components Page 5–16 Pro Force® Debris Blower
18237SL Rev A