Toro Pro Force 44552, Service Manual

Page: 14 / 134

Jacking Instructions
CAUTION
Failing to properly support the machine with appropriate jack stands
can cause the machine to move or fall and can result in personal
injury.
When changing the attachments, tires, or performing other services,
do the following steps:
• Use correct blocks, hoists, and jacks to raise and support the
machine.
• Park the machine on a solid level surface, such as a concrete
floor.
• Before you lift the machine, remove all the attachments that may
interfere with the safe and correct lift of the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
• Do not use the axle as a jacking point.
1. Position the machine on a level surface. Ensure that the blower engine is
shut off and remove the key from the key switch. Block the blower wheels
with chocks to prevent the machine from moving, or leave the blower
attached to a tow vehicle if possible. Engage the tow vehicle parking brake,
shut off the tow vehicle engine, and remove the key from the tow vehicle
key switch if applicable.
g233699
Figure 1
1. Wheel 2. Frame jacking point
2. Position the jack securely under the main frame of the blower. Do not use
the axle as a jacking point.
3. Carefully raise the machine off the ground.
4. Position jack stands under the main frame to support the machine.
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located
near any area of potential danger. If any decal becomes illegible or damaged,
install a new decal. Decal part numbers are listed in your
Parts Catalog ,
Operator’s Manual , and accessory Installation Instructions . Order replacement
decals from Authorized Toro Distributor.
Safety: Jacking Instructions Page 1–6 Pro Force® Debris Blower
18237SL Rev A