Toro GrandStand 74534TE, Operator'S Manual

Page: 24 / 72

Figure 23
Driving Backward
1. Move the right side motion control lever to the
center, un-locked position.
2. Slowly pull the motion control levers rearward
(Figure 24).
Figure 24
Stopping the Machine
To stop the machine, move the motion control levers to
neutral, move the right side motion control lever into
the neutral lock position, disengage the power take off
(PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake in Operation. Remember
to remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Pushing the Machine by Hand
The by-pass valves allow the machine to be pushed by
hand without the engine running.
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
To Push the Machine
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Lower the mower deck to the lowest height-of-cut
(HOC). This will allow access to the by pass valves.
3. Open the by-pass valve on both pumps by turning
them counter clockwise 1 to 2 turns. This allows
hydraulic fluid to by-pass the pumps and the wheels
to turn (Figure 25).
Note:
Rotate the by-pass valves a maximum of 2
turns so the valve does not come out of the body
causing fluid to run out.
24