4. If adjustment is needed, loosen the jam nut and
adjust the bolt to the correct distance. Tighten the
jam nut after adjusting the bolt (Figure 58).
5. Test the safety interlock system before operation.
G015609
1 6
2 3 4
4
2
5
6
Figure 58
1.
Proximity switch target
4.
Bolt attached to the motion
control lever
2.
Proximity switch
5.
Distance between 0.050
and 0.090 inches (1.27 to
2.29 mm) is needed
3.
Bolts and nuts
6.
Jam nut
Checking the Tire Pressure
Service Interval:
Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 12-14 psi
(83-97 kPa). Uneven tire pressure can cause an uneven
cut.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
Figure 59
Adjusting the Caster Pivot
Bearing
Service Interval:
Every 500 hours/Yearly (whichever
comes first)
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the dust cap from caster and tighten lock
nut (Figure 60).
4. Tighten the locknut until the spring washers are flat
and then back off a 1/4 turn to properly set the
pre-load on the bearings (Figure 60).
Important:
Make sure spring washers are
installed correctly as shown in Figure 60.
5. Install the dust cap (Figure 60).
43
Summary of Contents for GrandStand 74534TE
