Belt Maintenance
Checking the Belts
Service Interval:
Every 100 hours—Check the pump
drive belt.
Every 100 hours—Check the mower
deck belt(s).
Check belts for cracks, frayed edges, burn marks, wear,
signs of overheating or any other damage.
The signs of a worn mower belt are squealing while the
belt is rotating, blades slipping while you are cutting
grass, frayed belt edges, burn marks, and cracks. Replace
the mower belt if you detect any of these signs.
Replacing the Mower Deck
Belt for 91 cm Mowers
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bolts and remove the right belt cover
with the bolt attached to it.
4. Remove the spring from the anchor post on the idler
pulley arm (Figure 65).
5. Remove the worn mower belt (Figure 65).
6. Install the new mower belt around the clutch pulley,
deck pulleys and idler pulley (Figure 65 ).
7. Install the spring onto the anchor post on the idler
pulley arm (Figure 65 ).
8. Install the belt cover onto the cutting unit and secure
the bolt.
Figure 65
1.
Belt
3.
Spring
2.
Spring loaded idler pulley
Replacing the Mower Deck
Belts for 102 cm Mowers
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
Replacing the Right Mower
Deck Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bolts and remove the belt covers with the
bolts attached to them.
4. Remove the spring from the anchor post on the idler
pulley arm (Figure 65).
5. Remove the worn mower belt (Figure 65).
6. Install the new mower belt around the deck pulleys
and idler pulley (Figure 65 ).
7. Install the spring onto the anchor post on the idler
pulley arm (Figure 65 ).
8. Install the belt covers onto the cutting unit and
secure the bolts.
47
Summary of Contents for GrandStand 74534TE
