Engine Speed Mode
3 modes are available: L
OW
, E
FFICIENT
, and M
AXIMUM
.
•
L
OW
:
Low transport speed/Low idle for reducing
deck packing in wet mowing conditions.
•
E
FFICIENT
:
Medium transport speed and maximum
fuel economy and normal mowing conditions.
•
M
AX
:
Maximum transport speed/High idle for
extreme mowing conditions.
The panel illuminates showing the current engine
speed mode (Low is selected in
).
Safety Interlock Status Indicators
These illuminate when each control is in the starting
position (i.e., PTO disengaged, parking brake
engaged, motion-control levers in the N
EUTRAL
-L
OCK
position, and the operator is present).
•
The PTO must be disengaged, brake engaged,
and motion-control levers out (N
EUTRAL
-L
OCK
position) to start the engine. (You do not need to
be in the seat to start the engine.)
Note:
The starter cranks with the PTO switch in
the O
N
(pulled up) position; however, the system
disengages the PTO and a PTO reset error occurs.
Engaging the PTO requires you to reset the PTO
switch by turning it O
FF
(pushed down) and O
N
.
•
You must be in the seat while the PTO is engaged,
the parking brake must be disengaged, or the
motion-control levers must be moved inward;
otherwise, the engine shuts off.
•
The engine shuts off if either the left, the right,
or both levers are moved from N
EUTRAL
-L
OCK
position while the parking brake is engaged.
Note:
Refer to the machine
Operator’s Manual
to
check the safety interlock system.
Engine Temperature
A bar graph displays the engine temperature. When
the temperature is high and approaching an overheat
condition, the bar graph flashes. When the engine
has overheated, the bar graph fills completely.
Engine Speed
Displays the speed of the engine.
Fuel Level (if fuel sender is available)
The fuel level is shown on a bar display. An error
appears when the fuel level is low (approximately 1
gallon remaining in the tank).
Menu Selection Screen
The Menu Selection Screen displays when you place
the motion-control levers in the N
EUTRAL
-L
OCK
position
and press and hold the 2 outside LDU buttons.
g228165
Figure 5
1.
Outside buttons
2.
Menu selection screen
The Menu Selection Screen allows you to cycle
through the different menu options by pressing the
toggle button. When the desired menu option is
highlighted, press the enter button to select it.
Note:
All menu options are locked if the
motion-control levers are not in the N
EUTRAL
-L
OCK
position.
Press and hold the 2 outside buttons to return to the
default screen.
The menu selection screen allows you to cycle
through the following screens.
•
Maintenance and Service Menu (page 6)
•
Gauges and Meters Menu (page 8)
•
Advanced Settings Menu (page 10)
5
