Factory Defaults
This screen allows you to reset system settings back
to the factory default settings. Pressing the Enter
button brings up confirmation screen; press Y (yes) to
reset or N (no) to cancel.
Note:
Resetting the system returns the engine speed
settings and alarm settings back to the factory default
settings.
g030238
Figure 37
1.
Factory Defaults
2.
Reset
When the exit screen appears, press the enter button
to go back to the Menu Selection screen.
Returning to the Default
Screen (Engine-On or
Engine-Off)
There are 3 ways to return to the default screen:
•
Press the previous or next arrow keys until the
Exit screen appears then press the Enter button to
return to the Menu Selection screen.
•
Turn the ignition key to the O
FF
position and
either restart the engine or turn the key to the O
N
position.
•
Press and hold the 2 outside buttons.
Setting Engine Speeds
At startup, the system defaults to the Low engine
speed. The icon on the information screen is
highlighted.
•
Press the button below the Efficient Speed Mode
icon to increase the engine speed to the Efficient
engine speed.
The Efficient Speed Mode icon is highlighted.
•
Press the button below the Maximum Speed Mode
icon to increase the engine speed to the maximum
engine speed.
The Maximum Speed Mode icon is highlighted.
Note:
If you engage the PTO switch at any speed
setting, the engine speed increases to the mow speed.
Adjusting the
Electronically-Controlled
Low Mode Speed
Adjustment
When operating in low mow mode, press and hold the
Low Speed Mode button reduce the engine speed
(minimum of 2,250 rpm). Press the Low Speed Mode
button again to return the engine to the default setting.
Auto Idle Down Mode
If the operator leaves the seat and the safety interlocks
allow the engine to remain running, the system enters
the auto idle mode and automatically set the engine
speed to the low transport speed. When you return
to the seat, the system automatically returns to the
previously selected engine speed mode. If you select
another engine speed setting, the system exits the
auto idle mode and the engine runs at the selected
speed.
Error Messages
If an error occurs, a message displays in place of the
engine temperature, engine speed, and fuel level. In
addition to displaying the fault as text, the system
turns the LED red and sounds the audible alarm.
•
The system is capable of displaying the following
errors:
–
Service Engine Oil:
engine oil maintenance
is required.
–
Service Transmission Oil:
transmission oil
maintenance is required.
–
Low Oil Pressure:
low engine oil pressure is
detected.
–
Fuel Low:
fuel level is low
–
Engine Over Temperature:
engine over
temperature detected.
–
System Overvoltage>16VDC:
system voltage
is too high (greater than 16 V).
–
System Undervoltage<9VDC:
system voltage
is too low (greater than 9 V).
–
Clutch Overcurrent:
cutting clutch current is
too high.
–
Clutch Reset Required:
indicates that the
PTO switch must be turned off and then on to
reactivate the PTO clutch. It may also indicate
that the wing deck switch has been tripped (if
applicable).
13
