Toro 41106-220000101, Operator'S Manual

Page: 64 / 84

64
FILLING THE SOLUTION TANK:
BEFORE SPRAYING
IMPORTANT: Follow the chemical
manufacturer's instructions for mixing spray
solution to obtain desired application rate. Do
not add chemical to Tank until just before use.
The concentrate should not be poured into an
empty Tank: Fill tank about 3/4 full with clean,
clear water. With agitation ON, add chemical
concentrate slowly and finish filling Tank with
water. Dispose of excess chemicals, solution
and containers, per chemical manufacturer's
instructions.
Premix wettable powders in one or two 5-gallon
containers then slowly add premix to 3/4 tank of
clean, clear water with agitation ON.
The tank has been designed with its opening
offset to the left side of the tank. Fill from the left
side.
FILL FRESH WATER WASH TANK (See
FIG. 1):
In case of chemical contact with skin or eyes,
a fresh water wash tank has been installed on
the left side of the vehicle. Refer to the
Chemical Manufacturer's label for instructions
on seeking medical attention.
NOTE: Fill Fresh Water Wash Tank each
day of operation with clean water only.
Check to assure tank is full before each
operation.
CAUTION
CHEMICALS ARE HAZARDOUS AND CAN
CAUSE PERSONAL INJURY!
Carefully read the directions printed on
the chemical manufacturer's labels be-
fore handling chemicals. Instructions
on chemical manufacturer's container
labels, regarding mixing proportions,
should be read and strictly followed.
Keep spray material away from skin. If
spray material comes in contact with
body, wash it off immediately with clean
water and detergent.
Always wear goggles and other
personal protective equipment as
recommended by the Chemical
Manufacturer.
1. Fresh Water Tank2. Spigot
1. Turn Tank Spigot to ON position.
2. Hold contaminated area directly in water
stream. Flush thoroughly.
FIG. 1
1
1877
2