Toro 41106-220000101, Operator'S Manual

Page: 12 / 84

12
CAUTION
Chemicals are hazardous and can
cause personal injury!
Securely tighten all sprayer hose
clamp connections during intial set-up
to prevent leaks and hose blow-offs
while spraying system is in operation.
SPRAY SYSTEM:
NOTE: In the following instructions, "sealer",
refers to the Teflon Thread Tape.
NOTE: If optional Hose Reel is to be installed
on unit; install Hose Reel before installing
Boom. See Set-Up and Part's Manual supplied
with Hose Reel.
1.
Install Boom Bypass Hose into bottom rear of
Tank at the remaining port. Secure with U-
shaped Fork.
2. Remove Stop Pins in Boom Mount Assemblies.
Apply a heavy coating of grease to the tubes of
the two (2) Boom Mount Assemblies and insert
them into the Vehicle Frame until Angled Gusset
bottoms out against Vehicle Frame. (See FIG. 1)
1. Stop Pin 3. 1/2" x 18" screws
2. Boom Mount ASM
FIG. 1
NOTE: If installing the "Enclosed Boom" option
in place of the Standard Boom, DO NOT install
the two (2) Boom Hold-In Assemblies in Step
3 or the two (2) Boom Mounting Brackets in
Step 4.
3. Install the two (2) Boom Hold-In Assemblies
to the top of the Boom Mount uprights as shown
in FIG. 2, using four (4) 1/2" x 1-1/4" cap screws,
and flange nuts.
SETUP INSTRUCTIONS
4. Attach the two (2) "U"-shaped Boom
Mounting Brackets and the Valve Mounting Bar
to the third and fourth holes from the top of the
Boom Mount uprights with four (4) 1/2" x 1-1/4"
cap screws, and flange nuts. Torque to 75 ft-lbs
(102 N-m).
1. Existing Mounting 2. Control Valve
Brackets ASM
FIG. 3
5. Remove and discard the four (4) existing
Mounting Brackets from the Control Valve
Assembly. Using existing hardware, attach the
three (3) Mounting Brackets (provided in Parts
Bag) to the Control Valve Assembly. (See FIG. 3
above and FIG. 3A, page 13)
1802
2
1
FIG. 2
1813-1
3
1
1. Boom Hold-In ASM 3. Boom Mount Uprights
2. Valve Mounting Bar
2
1
1817