Toro 41106-220000101, Operator'S Manual

Page: 21 / 84

21
NEUTRAL INTERLOCK SWITCH:
The Multi Pro
®
1250 is equipped with a Neutral
Interlock Switch. The purpose of this switch is to
ensure that the vehicle will not start and the Neutral
Engine Speed Control will not engage unless the
Range Selector is in the NEUTRAL position.
The Neutral Interlock Switch is located
underneath the Left Control Panel and is
accessed by removing the Air Cleaner Cover. (See
FIG. 9)
Check and maintain the Neutral Interlock Switch
in a position that prevents the engine from starting
unless the Range Selector is in the Neutral
Position.
BEFORE OPERATING
Note: For Neutral Interlock Switch Maintenance,
see Maintenance, page 32.
FIG. 9
1. Neutral Interlock Switch
2. Air Filter
1884
CHECK TORQUE OF WHEEL NUTS:
Failure to maintain proper torque could
result in failure or loss of wheel and may
result in personal injury.
Torque front wheel nuts to 55-65 ft-lb (75-
88N-m) and rear wheel nuts or bolts to 45-
65 ft-lb (61 TO 88 N-m) after 1-4 hours
of operation and again after 10 hours
of operation and every 200 hours
thereafter.
WARNING
WARNING
Brake failure can cause loss of
control and result in serious injury or
death.
Test Brake function and correct before
operation.
IMPORTANT! After the "initial run-in"
(approximately one to two hours), check all the
MULTI PRO
®
1250 wheel fasteners for
tightness.
CHECK TIRE PRESSURE:
Check tire pressure every 8 hours or daily to
assure proper levels. Maximum air pressure in
both front and rear tires is 18 psi.
The air pressure needed is determined by the
payload carried. Once the desired pressure has
been ascertained, it is to be used and maintained
as a factor in the computer programming to
insure the accuracy of the spraying system.
INSPECT TIRES:
Check tire condition for wear or damage.
Operating accidents, such as hitting curbs, can
damage a tire or rim and also disrupt wheel
alignment; so inspect tire condition after any
accident.
Note: Your MULTI PRO
®
1250 is supplied with
self-adjusting brakes. Replace brakes when worn.
See MULTI PRO
®
1250 Parts Manual for
replacement. For Emergency/Parking Brake
Maintenance, see page 45.
1
2
3
3. Shield Panel L.H.
WARNING
If the engine can be started or the
Neutral Engine Speed Control can be set
without the Range Selector in the Neutral
Position, the Neutral Interlock Switch
circuit is faulty. DO NOT OPERATE THE
VEHICLE!