Tormach Autofeed Bandsaw AF50, Operator'S Manual

Page: 67 / 90

11: TROUBLESHOOTING
©Tormach® 2020
Specifications subject to change without notice. Page 67 UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
11.2.5 Noise or Machine Vibration
l
Problem The machine vibrates or operates loudly.
l
Cause There may be damaged components, or you may need to use a different blade or cutting speed.
You May Need
To...
Probability How-To Steps Need More?
Change the
blade or the
cutting speed.
High
l
Verify that the blade's TPI isn't too high: you must
use the correct blade for the material.
l
Verify that the cutting speed isn't too high: lower
the cutting speed, and then do a test cut.
Examine the behavior of the machine as it cuts.
For information, see "Choose a
Blade" (page 28) or "Change the
Speed" (page 31).
Examine the
workpiece setup.
High
l
Manual Operation Verify that the workpiece
isn't too loose: use the handwheel to tighten the
clamp on the front vise. If necessary, use a jig to
hold the workpiece.
l
Automatic Operation
Examine the vise clamps:
verify that there is 1/8 in. or less of a gap
between the clamps and the material. Then,
verify that the vise jaw clamping pressure isn’t
set too low for the material.
For information, see "Use
Automatic Mode" (page 34) or "Use
Manual Mode" (page 38).
Replace or
sharpen the
blade.
Medium Examine the blade for dullness. If it's too dull, sharpen
or replace it.
For information, see "Change a
Blade" (page 28).
Fill the oil in the
gearbox.
Medium Examine the oil level in the gearbox. If necessary, fill it
to an appropriate level.
For information, see "Replace the
Gearbox Oil" (page 42).
Replace the
motor fan cover
or the fan.
Low Examine the motor fan cover and the fan:
l
Motor Fan Cover If it's dented, replace it.
l
Fan If it's damaged or loose, replace it.
Email support@tormach.com to
contact Tormach Technical Support
for guidance on how to proceed.