11: TROUBLESHOOTING
©Tormach® 2020
Specifications subject to change without notice.
Page 57
UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
11.1.6 Material Slips in Vise Clamps
l
Problem
The material slips in the vise clamps during operations.
l
Cause
The air pressure to the vise jaws may be too low.
You May Need
To...
Probability
How-To Steps
Need More?
Clean the
bandsaw.
High
Examine the bandsaw for chip build-up. If necessary,
clean it of chips.
For information, see "Machine
Adjust the air
pressure to the
vise jaws.
High
Verify that the air pressure is set to at least 90 psi. If
it's not, adjust your regulator. Otherwise, examine your
air supply.
For information, see "Air
Tighten the
handwheel.
High
During manual operation, verify that the handwheel is
completely tightened. If it's not, tighten it.
For information, see "Manual