Toppro T2208, User Manual, Page: 26 / 52

6.5 Gate interface
DSP Control
Touch the switch ON to enable EQ function, it will illuminate
and synchronize with ON/OFF control in EQ page. Please set
values in EQ page because it is not adjustable here. This page
can only show the values. You can also load a preset, please
refer to load introduction section for the detail operation, the
loaded state will show in the middle box.
Touch Flat EQ to eliminate EQ settings and restore it to default.
In this area, you can touch the grid area to enter EQ page, for
the detail of EQ function, please refer to the EQ introduction in
section 6.7.
Touch the switch to enable Compressor function, then rotate Parameter Adjust
knob or slide long fader on the right LCD screen to adjust value of Threshold, which
will show in the middle box. During adjustment, corresponding figure change will
show in the Compressor grid.
In this area, you can touch the grid area to enter COMP page, for the detail of
COMP function, please refer to the COMP introduction in section 6.6.
Touch anyone of these controls to enter corresponding page.
It is the same with that in Assign interface in section 6.3.
Note: you can also rename the selected channel by long pressing CHXX.
Threshold
Compressor
0.0dB
ON
EQ
Rock Drums
ON Flat EQ
Load Save
Copy
Channel
Select
Channel
Solo
Mute
CH08
Parameter
Aux 1
-10.5dB
Level LIMIT
(dB)
16
12
7
3
-1
-5
-10
-14
-18
-22
-26
-30
(dB)
4
8
13
17
21
25
30
34
38
42
46
50
CLIP
10
7
4
2
0
-2
-4
-7
-10
-20
-30
Threshold
Release
Attack
50mS
100mS
0.0dB
Save Load
Gate
ON Default
Select
Channel
Copy
Channel
-10.5dB
CH08
Bank Select
Left
Bank Select
Right
Long
Faders
All Faders
DCA
Assign
Channel
Gate
Comp
PEQ
GEQ
FX 1
FX 2 Routing
System
EQ
26
6