TOPEX MobiLink
IP
Preliminary Manual
Base
Magnetic, diameter 2,8cm
Cable
Type RG174, length 2,5 m
End Connector
Nipple, male
Note:
The MobiLinkIP unit and its antennas should be placed as far as possible from appliances
or office equipment that is sensitive to radio interference (microwave ovens, copiers, TV
sets, PC displays, and multimedia systems). For best results, try to find a place of
maximum signal reception for the Mobile antenna
In addition, the antenna must NOT be located near heavy-duty equipment that may
generate electromagnetic interferences, such as electric motors or heaters.
Power up
Switch the MobiLinkIP on - the indicator LEDs will light up.
Remember that the adapter is the disconnection device (there is no POWER switch on
MobiLinkIP), so the 230 V
AC
socket-outlet must be installed near the equipment and must be
easily accessible.
Status indicators
MobiLinkIP has three optical indicator (bicolour LEDs - red and green or red and yellow) that shows
the status of the device, respectively of the Ethernet interface and that of the two mobile modules.
The indicators may light up continuously in red, orange or
green color, or flash to show status and data traffic.
The three LEDs are located on the upper right corner of
the MobiLinkIP case, above the two slots for SIM cards.
They are labelled respectively STATUS, MOBILE1 1 and
MOBILE 2.
Figure 7: LEDs location
Significance of LED indicators:
STATUS
: Shows the state of the equipment. Indicates the proper power supply and the state of the
Ethernet interface of MobiLinkIP.
Off = device not powered (no supply voltage), On, Red color = no ETH network is connected, On,
Orange color = ETH port connected to the local network, but no traffic, Orange blinking = ETH port
connected and data traffic present.
MOBILE 1
: Shows the state of the first mobile module.
Off = not installed (the respective module is disabled from software), red blinking = not registered or
SIM not present, lights up green = mobile module1 free (available), lights up red = mobile module1
busy (in a call).
MOBILE 2
: Shows the state of the second mobile module, same significance as first mobile.
Off = not installed (the module 2 is disabled from software), red blinking = not registered or SIM not
present, lights up green = mobile module2 free (available), lights up red = mobile module 2 busy (in a
call).
TOPEX S.A. +4 021.408.39.00
Page 23 of 80
