28
Potentiometer A
is used to adjust the soft stop period of the gate opener. Turn the potentiometer clockwise to
increase the soft stop period, and turn it counter-clockwise to decrease the soft stop period. The soft stop period
can be adjusted gradually from 1 to 5 seconds.
Potentiometer B
is used to adjust the auto close time of the gate opener. Turn the potentiometer clockwise to
increase the auto close time, and turn it counter-clockwise to decrease the auto close time. The auto close time
can be adjusted gradually from 3 to 120 seconds.
Potentiometer C and potentiometer D
are used to adjust the open interval and close interval time between
the master gate opener and the slave gate opener respectively. Turn the potentiometer clockwise to increase
the interval time, and turn it counter-clockwise to decrease the interval time. The interval time can be adjusted
gradually from 1 to 9 seconds.
Potentiometer E
is used to adjust the stall force the gate opener. Turn the potentiometer clockwise to increase
the stall force, and turn it counter-clockwise to decrease the stall force.
Maintenance
Warning:
Disconnect power before servicing.
1. Using a clean, dry cloth to wipe the gate opener shaft, and then apply a silicone spray to reduce its friction. In
cold climates where temperatures reach 1°C (30°F) or less, spray silicone on the actuator every 4~6 weeks to
prevent freeze up.
2. Regularly check gate hinges to make sure gate is swinging smoothly and freely. Grease hinges if needed.
3. Check your installation periodically, as hardware and posts will shift. Brackets may need to be adjusted or
hardware may need to be tightened.
4. Maintain the area around your gate. Keep the areas free of objects that can prevent the gate swinging freely.
NOTES:
1. Inspection and service should always be performed anytime a malfunction is observed or suspected.
2. It is suggested that while at the site voltage readings be taken at the operator. Using a Digital Voltmeter, verify
that the incoming voltage to the opener it is within ten percent of the opener
’s rating.
3. Refer to the instructions on how to check gate force and sensitivity adjustments.
Summary of Contents for A3132
Page 6: ...3 A3132 Parts List...
Page 7: ...4 A5132 A8132 Parts List...
