Topcon System 350, Operator'S Manual

Page: 9 / 112

X30 Spreader Controller
0-6
Radio and Television Interference
This computer equipment generates, uses, and can radiate radio-
frequency energy. If it is not installed and used correctly in strict
accordance with Topcon Precision Agriculture instructions, it
may cause interference with radio communication.
You can check if interference is being caused by this equipment
by turning the Topcon equipment off to see if the interference
stops. If the equipment is causing interference to a radio or other
electronic device, try:
 Turning the radio antenna until the interference stops
 Moving the equipment to either side of the radio or other
electronic device
 Moving the equipment farther away from the radio or other
electronic device
 Connecting the equipment to another circuit that is not linked
to the radio.
To reduce potential interference, operate the equipment at the
lowest gain level that will allow successful communication.
If necessary contact your nearest Topcon Precision Agriculture
dealer for assistance.
Changes or modifications to this product not authorized by
Topcon Precision Agriculture could void the EMC
compliance and negate authority to operate the product.
This product was tested for EMC compliance using Topcon
Precision Agriculture peripheral devices, shielded cables
and connectors. It is important to use Topcon Precision
Agriculture devices between system components to reduce
the possibility of interference with other devices.