Topcon System 350, Operator'S Manual

Page: 33 / 112

Chapter 2 - Implement Setup 2.4 Setting up Implement Geometry
X30 Spreader Controller
2-13
2.4 Setting up Implement Geometry
Follow these steps to configure the implement geometry.
1. From the menu, select Geometry.
2. Select a measurement. The type of measurement will
appear in the Title Bar.
 Swath width measures the width of the implement
(that is, the width of the area that is treated during
one pass of the implement).
 Overlap measures the width of the overlap between
two adjacent rows.

Implement offset measures the distance between the
hitch point and the application end of the implement.
 Inline Offset measures the off-centre offset of the
implement relative to the hitch point. Enter a
positive number if the implement is shifted to the
right and a negative number if it is shifted to the left.