Topcon Motorgrader, Operator'S Manual

Page: 85 / 172

Laser Receiver Setup
P/N 7010-0344
4-15
Set both sides of the cutting edge on the ground, and raise or lower
the receiver to get an On-Grade signal. This can be done by just
pushing the two red buttons on the Smart Knobs, and the Trackerjack
will search up and down the vibration pole and lock onto the laser
beam.
Figure 4-21.
Switch to Automatic, and grade a short pass.
Figure 4-22.
Using the grade rod with detector, check the grade. Cut behind the
machine.
Figure 4-23.
+
+
+