Topcon Motorgrader, Operator'S Manual

Page: 32 / 172

Operation
Motorgrader System Five Operator’s Manual
2-10
• Trim (Slope Control Only)
Pressing the Trim button will allow the operator to adjust or
"trim" the Blade Slope Sensor Calibration in order to compensate
for the blade's cutting edge wear. This adjustment can be done
"on the fly" in automatic cross slope operation. This calibration
should be performed as the cutting edge wears. When operating
in harsh material conditions, the slope calibration should be
checked more often. (Refer to the Trim Calibration section within
this manual).
Figure 2-15.
TRIM
System System
Five Five
System
Five
System System
Five Five
System
Five
CONTROL MODE
GAINS TRIM /
+
/
—
/ SET MENU
2.0% 0.0 F
T
+
BLADE WEAR CAL (TRIM)
ENTER EXIT
2.0%
TURN T HE G RADE
KNOB TO G ET T HE
BLADE TO M ATCH