GR-5 Configuration
GR-5 Operator’s Manual
3-16
• The settings can be read-only (marked by the
icon) or
changeable (marked by the icon). Clicking on the
corresponding line in the Value column opens a field to enter or
select from the drop-down list a needed value (see Figure 3-10).
Figure 3-13. Settings - Settings Tab
• Baud Rate, baud
- specifies the baud rate of the modem's serial
port connected internally with the receiver's serial port, by default
with hardware flow control. It can be 19200, or
38400
(default).
•
Current Frequency, MHz
- sets the operating frequency used for
data transmission / reception (from the list defined by the user).
•
Signal Threshold, dBm
- sets the modem sensitivity (default -
112
dBm). Possible values -
118
..-
80
.
•
Output Power, mW
- sets the appropriate level of output power.
Possible values: 100, 200, 500
,
and
1000
mW (default).
•
FCS
- sets to
OFF
for configuring the radio-modem with a
dedicated channel. Select
Master
for the Base, and
Slave
for the
Rover.
This page is intentionally left blank
Summary of Contents for GR-5
