Topcon GR-5, Operator'S Manual

Page: 115 / 202

MINTER Configuration
P/N 7010-1004
3-43
• Shows the status (high charge, intermediate charge, or low
charge) of the battery (BATT LED).
• Shows the power status for the receiver (BATT LED).
• Shows the status of the modem and if it receives signals (TX RX
LED).
• Shows the status of the GSM or CDMA modem (TX RX LED).
Use PC-CDU to configure MINTER settings. The procedure below
describes the most common settings; refer to the
PC-CDU Reference
Manual
for other possible MINTER configurations.
Perform the following to configure MINTER:
1. Connect the receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-21 for this procedure.
2. On the PC-CDU Main window, click
File Connect
.
3. On the
Connection Parameters
dialog box, enable RTS/CTS
handshaking (Figure 3-39).
See “Connecting the Receiver and a Computer” on page 2-21 for
details on setting other parameters.
4. Click
Connect
.
Figure 3-40. Connection Parameters – MINTER Settings
5. Click
Configuration Receiver
then click the
MINTER
tab, set
the following parameters and click
Apply
(Figure 3-40). See the
following pages for descriptions of these parameters.
•
Recording interval
on page 3-43
•
Elevation mask for log file
on page 3-43
•
File name prefix
on page 3-43