1
0
Push
“
STOP
”
, stop working.
(4) Press
“
UP
”
button , the mainframe stops, Saw Bean lift till touch the
High-limit Switch. Press
“
DOWN
”
button , Saw Bean falls.
(5) Press the "FASTEN" button, the vise clamping
(6) Press the "RELEASE" button then vise loose.
(7) When rotate "STEPLESS SPEED CONTROL" knobs by clockwise direction,
the feed speed Increase, counterclockwise rotation makes speed slow down and
finally stop.
(8) When one of the safety shields is not closed and the saw blade is broken,the
machine will be powered off and cannot be started.
2.Other operation agencies
Length of Work piece controls the block
Adjust the lock nut on the locating rod to determine relative position between one
point of the work piece and saw blade cut.
Ⅸ
MachineTool adjustment
1 Place the machine on the no vibration ground to check whether the machine intact,
and clean machine with antirust oil.
2 As shown in Figure 4, introduce four wire three phase to the wiring board on
electrical box from outside. Open the blinds of hydraulic oil and fill hydraulic oil 46#,
unto the surface of Filter. Connect the power supply, instruction light is on, and rotate
emergency stop button by clockwise to connect the control power, and press the
