1
4
(4).Tight locking nut of Motor Block.
(5). Cover the Pulley
5. The cutting efficiency of easy cutting materials is usually, cut hard materials
should be lower. For example: take the iron as describing, if the iron in thin or
powder, they should increase the cutting speed; and if the iron is charred and thick,
should lower the cutting speed. The iron should be in roll with the correct cutting
speed, see figure 16.
6. The new Blade "running-in"
New saw blade must be carried out "running-in" before starting cutting; Otherwise,
they would shorten the life and become not effective cutting.
7. Provisions of Bundle cutting.
When in buddle cutting, " the hydraulic compactor
”
(Customers purchase by
themselves) should be installed, which is the device compress with the clamping Vise.
Chart 13.
Figure 13
Press Device
Increase Cutting Rate
Sawing Direction
Speed Direction
Powder or thin Scrap iron
Speed and Cutting rate right
Scrap iron in roll
Speed Direction
Sawing Direction
Decrease speed and Cutting Rate
Charred thick Scrap iron
Sawing Direction
Speed Direction
