TH2826 Operation manual
Ver1.0
◇
1
Chapter 1
The introduction and installation
Thanks for purchasing our products! The basic performance will be introduced firstly in this
chapter, then the necessary inspection after you receive the instrument, and also the conditions
before installing the instrument.
1.1
Introduction
TH2826 series component tester is the new generation impedance tester in China which
meets the LXI standard
，
it can fit all test requirement of component and material with its 0.1%
basic accuracy and 20Hz
～
5MHz frequency. It can test low ESR capacitor and high Q
inductor and also be applied in analyze of the electrical performance in microphone, oscillator,
inductor, ceramic capacitor, LCD, variode, transformer.etc.
TH2826 series is a powerful tool for electrical component design, inspection,QC and
manufacture. It can be more suitable for point inspector, curve analyze of frequency response of
piezoelectric component .etc in auto production line with its high test speed. Its variable
impedance-outputting mode can fit to different standards. With its promitable
performance ,TH2826 series can realize the different tests of commercial and military standards
as IEC and MIL.
1.2
Inspection
Please check if the instrument was worn out in the transportation, we don’t recommend you to
charge the instrument if the cover of instrument is worn out.
1.3
Power connection
（
1
）
Feed voltage range
：
100
～
120 V ac or 198
～
242 V ac. In relate with the power
setup on the rear panel.
（
2
）
Feed frequency range
：
47
～
63 Hz.
（
3
）
Feed power range
：
No less than 80 VA.
（
4
）
Power inputting phase line L, null line N and ground line E should be same as plug.
（
5
）
The instrument is designed to reduce the clutter interference from AC power input
，
please use it in the low-noise environment, if not ignore, please install power filter.
——————————————————————————————————
Warning
：
In order to prevent leakage or people being hurt, user has to connect the
ground line to the ground
.
——————————————————————————————————
