TH2826 Operation manual
Ver1.0
◇
19
3.3.6 (AUX)
Bin count value of current auxdiary bin is displayed.
3.3.7(OUT)
Bin count value of current out bin is displayed.
3.3.8File management
Refer to 4.2<File management> function.
3.3.9Auxdiary tools
TH2826 has the function of bin count. The compare function is sorted as different bins, when
the component of each bin is counted. The Max. value 999999 can be displayed. When the
count value is over this value
,
the screen displays“----”. However, the internal counter can
count nominally, so the count value can be read via IEEE488 interface.
Operational step of bin count function
:
Execute the following operation
,
set bin count ON/OFF function on
<Bin count display>
。
1)
On
<Bin count display>
page
,
move cursor to tools zone. The following softkeys will be
displayed.
Count
No count
Rs count
2)
Press
Count
to open count function. “
►
” will be displayed at the left of “Count”
3)
Press
No count
to turn off count function. “
►
” will not be displayed at the left of
“Count”
4)
Press
Rs count
,
“
☺
:
Re count confirm?” will be displayed.
YES
NO
5)
Press
YES
,
all bib count value will be reset as 0.
6)
Press
NO
,
cancel the reset operation.
3.4 <List sweep display> page
In TH2826 Max.10 points of frequency
,
level or DC bias can be output on
<List sweep
setting>
page. Each list sweep test point can be set high and low value, which will be tested
automatically; also the result is compared with limit value.
Press
[LCRZ]
,then
List sweep
,
to enter
<List sweep display>
page. As figure 3-4
: