Toledo PWi Forging, User Manual

Page: 75 / 92

PWi Forging User’s Manual
Doc #17663 Rev A Page
Toledo Integrated Systems
73
4
4
:
:
Calibration Information Label
The Calibration Information Label is provided to document the Gain Numbers (CAL#) and other important
configuration data. This card is located inside of the unit on the door. Below is an example of the
information that should be documented.
1)
Cal By
The name of the person that performed the calibration procedure.
2) Date
The date that the calibration was completed.
3) Press No.
The press on which the monitor is installed.
4) Address
The network/communication address for the monitor.
5) Capacity (CH0)
The total capacity of the press. For a double-action press, this is the capacity of the outer slide.
6) Unit
The type of load being measured. Common examples include Tons and kN (kiloNewtons).
7) Thres. Value
If the trigger method is set to Threshold , check this box and record the configured threshold value.
8) Probe
If the trigger method is set to Probe , check this box.
9) CAL# (CH1-4)
Record the Gain Numbers from step 11 of the Calibration Procedure here.
10) STI Value
If the mode is set to STI , check this box and enter the STI configuration number here.
11) Delay Value
The configured delay value, if used.
12) Notes
Enter any important notes related to the monitor’s configuration in this area.