Toledo PWi Forging, User Manual

Page: 15 / 92

PWi Forging User’s Manual
Doc #17663 Rev A Page
Toledo Integrated Systems
13
AC Power Connection and Configuration (AC unit only)
AC power is connected to the PWi Forging’s Analog Board as shown in Figure 1.5. Use Conduit
Hole #3 (see Figure 1.4) for the AC Power Wiring. Use the proper fuse as indicated.
With the proper jumper settings, the PWi Forging can be powered by either 110 VAC or 220 VAC
(Factory set at 110 VAC.) The jumpers are located on the Analog Board as shown below.
L2 = NEUTRAL
G = GROUND
L1 = HOT
AC Power Connection
Fuse: Type TR5
Slow-Blow

500mA@110V

250mA@220V
A
C
B
A
C
B
220V
110V
220VAC = Jumper C Only
110VAC = Jumpers A & B
Figure 1.5: AC Power Connection and Jumper Settings