Toledo PWi Forging, User Manual

Page: 11 / 92

PWi Forging User’s Manual
Doc #17663 Rev A Page
Toledo Integrated Systems
9
Mounting the PWi Forging – Standard Installation
Note: This section is for mounting standard PWi Forging units. If the flush mount option
was purchased, refer to the next section for instructions on mounting the PWi Forging with
the flush mount option.
The PWi Forging is an electronic instrument and must therefore be protected from physical stresses
such as shock and vibration. Shock mounts are provided with every standard PWi Forging for this
purpose. Failure to use these shock mounts may result in premature failure of the instrument and
possibly void your warranty.
The PWi Forging may be mounted directly to the press or to an adjacent structure. It should be
positioned so that the display is easily read and the instrument is readily accessible. Figure 1.1
below provides the mounting dimensions and demonstrates the proper attachment of the provided
shock mounts.
6
.3
5
"
[1
6
1
m
m
]
8.90" [226mm]
6.88" [175mm]
6
.8
8
"
[1
7
5
m
m
]
1/4" - 20 STUD
SHOCK MOUNT ASSEMBLY
5.00" [127mm]
+23
PEAK
-21
+22
RUN ALARM
+25
-13
Figure 1.1: Standard Mounting Dimensions