Toledo Transducers Press Pilot 150, Manual And Installation Manual

Page: 10 / 120

_
Doc# 16302 Press Pilot 150 Manual
Page 8
1
Incoming Power Connections
L1 and L2 – Incoming 120 VAC
The customer supplied120VAC power must be from a clean
and continuous source. The PP150 has its own internal
+24VDC power supply for all I/O applications. This DC
power should only be used for I/O on the Press Pilot, and
is limited to 1Amp service.
2
User Inputs
I. Run/Inch Buttons
The system requires one set of two Run/Inch Buttons in
order to function, and is expandable up to four sets. Each
button must have a set of normally open and normally
closed contacts. The inputs into the PP150 are labeled “L-
RUN(x) NO/NC” and “R-RUN(x) NC/NO” where ‘x’ is the
station number of the run buttons, NC stands for
Normally closed, and NO stands for normally open. Anti-
tie down has been built into the system in order to inhibit
the ability to “tie down” one or both of the run buttons. An
anti-tie down fault will occur within 500ms (milliseconds)
of an incorrect contact state on the run buttons. This
fault is automatically reset when an anti-tie down situation
is cleared.
II. Prox Check Input
The system requires a proximity switch to check position in a
settable window throughout each stroke. The proximity
switch must be mounted separately from the
resolver/encoder in order to account for chain break or
slippage on the press position device. A fault will be
generated if the prox switch cycles twice without seeing the
BCAM or TCAM change state. A fault will also be generated
if the prox switch does not cycle inside the window.
III. Fault Reset Button
The PP150 Reset Button will reset any current PP150
fault when pressed. This button needs to have one
normally open contact sending a signal to the “FAUL RST”
input on the PP150.
IV. Arm Continuous Button
The system requires the use of a Prior Action “Continuous
Arm” Button and should be equipped with a normally open
contact sending a signal to the “arm cont” input on the
PP150. When the mode selector switch is in continuous
mode and this button is pressed, “Continuous” will be