Toledo Transducers Press Pilot 150, Manual And Installation Manual

Page: 25 / 120

_
Doc# 16302 Press Pilot 150 Manual
Page 23
II. RESOLVER OFFSET/Encoder Calibration
(Only for Resolver) (Only for Encoder)
The selection for the Position control will determine which
screen above is displayed.
The left screen is where the user sets the offset for the
resolver in order to program the correct resolver angle. This
page is only visible when Resolver has been chosen from the
Position Control page. The resolver offset is used to adjust the
PP150’s position to the resolver’s actual position. To determine
the resolver offset needed, stop the press at a known position,
then note the position on the PP150. Subtract this angle from
known position to get the resolver offset. To change the
resolver offset, press the key.
The right screen is where the user sets the desired angle when
using an encoder for position. Stop the press at a known
position, enter the desired angle then put it in cal mode by
checking cal mode on. It will say “in cal mode…inch press once”.
Inch the press one time. The PP150 will come out of cal mode
automatically once the encoder Z-pulse has toggled on.
III. CAM SETTINGS
This screen is not visible when Hard Cams are chosen on the
Position Control screen.
This page is only visible when Resolver or Encoder is chosen
from the Position Control screen, and is where Cam settings can
be changed. See the graph in Chapter 2 Section XIII for typical
Cam settings. To change the cam settings, press the right set of
Up/Down keys to scroll to the cam settings to change, and press
the
key.