Toledo Transducers Press Pilot 150, Manual And Installation Manual

Page: 13 / 120

_
Doc# 16302 Press Pilot 150 Manual
Page 11
XI. Resolver Inputs
To incorporate the different methods for tracking press
position, the PP150 is equipped with the ability to run off
three separate systems. Resolver based systems create
cams dependent on an absolute press position. The PP150
has the ability to run up to 1700 stokes per minute using
the resolver for press position. Connect the resolver for
the system using inputs R1, R2, S1, S2, S3, S4, and SHLD.
These inputs are found on the latch side of the PP150.
Refer to the electrical schematics for wiring a resolver,
and Chapter 5 Section II on how to calibrate the Resolver.
Encoder Inputs
An encoder based system creates cams dependent on an
automatically calculated offset, and the ‘z’ pulse from the
encoder. The PP150 has the ability to run up to 500 stokes
per minute using the Encoder for press position. Connect
the Encoder to inputs ENC A, ENC B, and ENC Z. Refer to
the electrical schematic for wiring the encoder, and
Chapter 5 Section II on how to choose the encoder as the
default position monitor.
XII. Clutch Valve Fault Monitor
The system is equipped with a clutch solenoid valve fault
input that needs to be on at all times. Anytime this input is
not on a clutch valve monitor fault will occur. This fault
can only be reset if the input is on.
(Wire this input “on” if
the solenoid valve does not have a fault contact)